
Even color and tight joints from garage to road
Driveway Paver Sealing in Hilliard, FL
Call (904) 980-0807 for a free driveway paver sealing estimate in Hilliard, however long the drive.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Do you seal paver driveways in Hilliard, and when would the estimate visit be?
A local contractor seals paver driveways all around Hilliard, FL, and replies within 1 business day, usually much sooner. You get a written number for free, with no pressure to say yes. Call (904) 980-0807 to be put on the list.
Out here a driveway is often the biggest paved piece on the property. It carries every tire turn, oil drip and hot afternoon, so the joints empty and the color fades there first. Sealing packs the joints and brings the color back, and a Northeast Florida washing company says it helps hold sand in place through summer storms. Share roughly how long your drive is when you send in the short form.

What wears out a paver driveway faster than a patio?
Weight and turning do. Cars twist the pavers at the garage door and at the mailbox end, and that grinding pushes sand out of the seams. Sun does the rest, since a drive with no shade bakes from morning to evening. That is why a price guide puts driveways closer to three years between coats while shaded patios stretch toward five. To have yours looked over, call (904) 980-0807.
Oil is the other enemy. Premier Coatings, a Florida company, says sealing reduces staining from oil, grease and rust, which gives a contractor time to treat a drip. Ask the contractor what happens to older stains when you send in the short form.
Paver Sealing Hilliard Is Proud to Serve Northeast Florida
What does it cost to seal a long driveway near Hilliard?
Cost climbs with square feet, so a long country drive adds up. The only published range for the full job is $1.75 to $3.25 per square foot from a washing company. A price guide says the rate drops on bigger areas, $1.50 to $2.50 for 800 to 1,200 square feet. Add $0.75 to $1.50 per square foot if failed sealer has to come off. Get a number for your length when you send in the short form.
| Driveway | Typical example | Full job at $1.75 to $3.25 | Big-area guide rate |
|---|---|---|---|
| 600 sq ft | Two cars side by side | $1,050 to $1,950 | between the guide's bands |
| 900 sq ft | Deep drive and turnaround | $1,575 to $2,925 | $1,350 to $2,250 |
| 1,200 sq ft | Long drive with a side pad | $2,100 to $3,900 | $1,800 to $3,000 |
| 2,000 sq ft | Estate-length drive | $3,500 to $6,500 | above the guide's list |
The figures multiply published per square foot rates and are not quotes. The guide's 800 to 1,200 square foot band is applied only to the two middle rows.
Which sealer works on a driveway that carries cars?
Cars ask for a sealer that grips and holds color. Unilock says solvent-based sealers last about four to five years and suit heavy traffic, and water-based ones are low in VOCs with a lower gloss. A price guide adds that film-forming products give the wet look and penetrating ones cost less and wear sooner. Ask the contractor to name the product and its coverage rate, and call (904) 980-0807 if you want them to explain why.
Gloss matters at the garage, too. Unilock warns that high gloss can be slippery when wet, and a rain shower on a sloped drive is when that shows. Ask for a matte or low sheen sample when you send in the short form.
Why do pavers sink on some Hilliard driveways?
Soft sand underneath is the usual cause. USDA describes one Nassau County flatwoods soil, the Kingsferry series, as very poorly drained sand with a water table within 12 inches of the surface for two to six months. A heavy truck on a base like that leaves ruts, and a coat of sealer will not lift them. Ask whether leveling is part of the plan when you send in the short form.

How long until I can drive on it, and what about the sprinklers?
Plan on a day or two. The paver industry association says to keep traffic off until the sealer is dry, typically 24 hours. Unilock asks for up to 48 hours of dry weather and for automatic sprinklers to be off, since water trapped under sealer leaves white marks. Tell the contractor where your sprinkler zones start when you send in the short form.
Does a sloped or hot driveway change the plan?
Yes, both do. The industry association recommends joint stabilizer on slopes over 7 percent so sand stays put in a downpour. Unilock says pavers that are too hot can stain or peel the coat, so work starts when the surface cools into the 50 to 90 degree range. In Nassau County the July average high is 90.6 degrees, so morning starts are common. Call (904) 980-0807 to talk through your drive.
Which steps does the driveway sealing process follow?
1. Walk it and measure
The contractor paces the length and notes cracks, low spots and old sealer.
2. Wash with a surface cleaner
A rotary head gives an even wash across a long drive. The paver industry association says steel brushes are not recommended.
3. Sand and let dry
Joints are refilled and the drive dries until it passes the touch test, usually about a day.
4. Spray, roll and mark off
Sealer goes on in one continuous pass so no spot is layered twice, and cones mark the drive until it cures.
Each step comes in the same order on every job. To ask about any of them, call (904) 980-0807.
Where does a Hilliard driveway usually go wrong first?
Four spots show trouble early, and each has its own cause. A contractor looks at all four on the first walk. To have yours checked, call (904) 980-0807.
The garage apron
Tires turn here, so the joints empty and the pavers can shift. Sand is replaced before any coat.
The edge by the lawn
Sprinkler spray and grass clippings sit on the border pavers, and orange iron marks show up here first.
The oil spot
A parked car leaves a dark patch that needs its own cleaner, tried on a small spot, before the wash.
The shaded stretch
Under a tree the pavers stay damp, grow algae and need extra drying time, about a day according to Unilock.
Should the whole driveway be sealed, or only the faded part?
A faded strip at the garage invites a patch job, and patches show. Unilock says to apply sealer in one continuous pass so no spot is layered twice, because layers leave uneven gloss. A line down the middle of a drive is easy to see from the road. Ask a contractor how they would blend a partial job when you send in the short form.
Sealing only the worn part can make sense on a very long drive with a clean, sound section near the road. The contractor can break the work at a natural joint such as a turnaround or a change of pattern. Call (904) 980-0807 to talk through where that break could go.
How is the lawn edge, mailbox and landscape lighting protected?
Overspray is a real concern next to grass and beds. Unilock lists a flat metal sheet held along the edge to shield it from overspray, and the contractor masks lights, posts and the garage door. The sprinklers are shut off for the job, which the paver industry association and Unilock both ask for. Mention a mailbox, post or low light along the drive when you send in the short form.
Is it worth sealing a driveway before selling a Hilliard home?
Many owners think so, because the drive is the first paved surface a buyer sees. About 78 percent of occupied homes in the 32046 ZIP are owner occupied and the median home value is $234,800, according to zip-codes.com, so a driveway that looks cared for matters to a lot of households. A clean, dark, full-jointed drive is a small cost beside that value. To price it, call (904) 980-0807.
What do sealed driveways look like near Hilliard?








Frequently Asked Questions
How much should it cost to seal a paver driveway?
Plan on $1.75 to $3.25 per square foot for the clean, sand and seal together, the range a Northeast Florida washing company posts. A 900 square foot drive comes to about $1,575 to $2,925. Failed old sealer to strip and joints to refill both add to that.
How much is paver sealer per square foot?
The product is a small slice. Unilock, a paver maker, says a gallon of water-based or solvent-based sealer costs about $80 to $150 and covers roughly 80 to 150 square feet. That works out to roughly $0.53 to $1.88 per square foot in material before labor.
How much does it cost to seal outdoor pavers?
Outdoor pavers all follow the same published band, $1.75 to $3.25 per square foot for a full job. A price guide says brick and stone can run 15 to 30 percent higher and small areas cost more per foot than big ones. A long driveway often prices lower per foot.
Is it good to seal pavers in Florida?
On a driveway, yes in most cases. A Northeast Florida washing company says summer storms pull sand from joints, and sealing helps hold it. The tradeoff is another coat every few years.
Can I drive on the driveway right after it is sealed?
Not right away. The paver industry association says to keep traffic off until the sealer is dry, typically 24 hours, and Unilock asks for up to 48 hours of dry weather to cure. Many owners park on the street for a night or two.
Is a long Hilliard driveway sealed by roller or sprayer?
Long drives usually go to a sprayer. The paver industry association says hand rollers suit areas under 1,000 square feet, and Unilock lists a sprayer with an adjustable nozzle. Rollers still smooth the coat and reach the edges.
Will sealer stop oil drips on my pavers?
It slows them. Premier Coatings, a Florida company, says sealing reduces staining from oil, grease and rust. Old marks still need a cleaner made for that stain.
Does a gravel or dirt road leave marks on sealed pavers?
Tires can track fine dirt and gravel onto the drive, and it scuffs a fresh coat while it is still curing. The paver industry association says to keep traffic off for about 24 hours. Many owners also sweep the apron after the coat is hard, which keeps grit off the finish.
Does a sloped driveway change the job?
Yes, because slope moves joint sand. The paver industry association recommends joint stabilizer on slopes over 7 percent. Mention any slope near the garage or the road when you ask for a price.
Want a price on the driveway?
Pick up the phone or send the short form, and a contractor writes back within 1 business day, usually much sooner.
Free, no obligation
